▼
Coated Dead-ends are designed for direct application over conductors jacketed with neoprene, polyethylene, vinyl, or rubber. The sub-setted rods in each leg, bonded together with neoprene, exert a low radial pressure without damaging the jacket. Because it is not necessary to skin the plastic covering, the same Dead-end can be used for either aluminum-base or copperbase conductors.
• Manufactured from aluminum alloy wire.
• Designed for direct application over conductors jacketed with neoprene, polyethylene, vinyl, or rubber.
Application Procedures
Catalog Pages
Coated Dead-ends are designed for direct application over conductors jacketed with neoprene, polyethylene, vinyl, or rubber. The sub-setted rods in each leg, bonded together with neoprene, exert a low radial pressure without damaging the jacket. Because it is not necessary to skin the plastic covering, the same Dead-end can be used for either aluminum-base or copperbase conductors.
• Manufactured from aluminum alloy wire.
• Designed for direct application over conductors jacketed with neoprene, polyethylene, vinyl, or rubber.
Application Procedures
Catalog Pages
Coated Dead-ends are designed for direct application over conductors jacketed with neoprene, polyethylene, vinyl, or rubber. The sub-setted rods in each leg, bonded together with neoprene, exert a low radial pressure without damaging the jacket. Because it is not necessary to skin the plastic covering, the same Dead-end can be used for either aluminum-base or copperbase conductors.
• Manufactured from aluminum alloy wire.
• Designed for direct application over conductors jacketed with neoprene, polyethylene, vinyl, or rubber.
Application Procedures
Catalog Pages
